Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cold start/idle Issue!
#16
Question about "the gasket trick"............Is the TBI base gasket supposed to be solid at all times or just for the troubleshooting steps you're describing? I have a 90 Tracker, 5spd, 4WD. I usually have to cut out the arch in your picture (red arrows) whenever I replace the gasket (not sure why they don't come pre-cut) but I wasn't sure about the holes.
Reply


Messages In This Thread
Cold start/idle Issue! - by tquick79 - 04-22-2019, 04:13 AM
RE: Cold start/idle Issue! - by fixkick - 04-22-2019, 04:59 AM
RE: Cold start/idle Issue! - by tquick79 - 04-22-2019, 05:20 AM
RE: Cold start/idle Issue! - by fixkick - 04-22-2019, 05:05 AM
RE: Cold start/idle Issue! - by tquick79 - 04-22-2019, 05:48 AM
RE: Cold start/idle Issue! - by fixkick - 04-22-2019, 08:29 AM
RE: Cold start/idle Issue! - by tquick79 - 04-22-2019, 09:51 AM
RE: Cold start/idle Issue! - by tquick79 - 04-22-2019, 03:00 PM
RE: Cold start/idle Issue! - by fixkick - 04-22-2019, 10:03 PM
RE: Cold start/idle Issue! - by tquick79 - 04-22-2019, 10:39 PM
RE: Cold start/idle Issue! - by fixkick - 04-23-2019, 12:30 AM
RE: Cold start/idle Issue! - by tquick79 - 04-23-2019, 01:19 AM
RE: Cold start/idle Issue! - by fixkick - 04-23-2019, 04:05 AM
RE: Cold start/idle Issue! - by tquick79 - 04-23-2019, 04:57 AM
RE: Cold start/idle Issue! - by fixkick - 04-23-2019, 10:06 PM
RE: Cold start/idle Issue! - by JCTracker - 12-24-2019, 08:22 AM
RE: Cold start/idle Issue! - by fixkick - 12-24-2019, 08:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)