Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Catconverter burn-up..
#12
Quick response before I have to step into work- did a lot of reading through the the site yesterday, noticed that standard plenum vacuum at hot idle should be 20 inHg, mine is stable at 8.. so I may have a vac leak somewhere, probably contributing. I have a new VSV2, and nothing under the hood is "custom" I've gone to great lengths to make all the mechanical components as original as possible. Header was cracked bad, currently running a dougthorley, no funky tube, goes directly to Cat inlet. Cat hangs from rubber grommets so I'm sure it is bouncing around a bit, also maybe contributing. my scanner will log/save so I'll pull down the info and post. thank you!! I'll update again asap
Reply


Messages In This Thread
Catconverter burn-up.. - by TomPrestin - 11-19-2019, 06:40 AM
RE: Catconverter burn-up.. - by fixkick - 11-19-2019, 09:07 AM
RE: Catconverter burn-up.. - by fixkick - 11-19-2019, 09:10 AM
RE: Catconverter burn-up.. - by TomPrestin - 11-19-2019, 09:33 AM
RE: Catconverter burn-up.. - by fixkick - 11-19-2019, 11:14 AM
RE: Catconverter burn-up.. - by TomPrestin - 11-19-2019, 12:25 PM
RE: Catconverter burn-up.. - by fixkick - 11-19-2019, 10:45 PM
RE: Catconverter burn-up.. - by TomPrestin - 11-19-2019, 09:23 AM
RE: Catconverter burn-up.. - by fixkick - 11-19-2019, 10:55 PM
RE: Catconverter burn-up.. - by fixkick - 11-19-2019, 11:09 PM
RE: Catconverter burn-up.. - by TomPrestin - 11-21-2019, 06:39 PM
RE: Catconverter burn-up.. - by fixkick - 11-20-2019, 12:05 AM
RE: Catconverter burn-up.. - by TomPrestin - 11-20-2019, 02:13 AM
RE: Catconverter burn-up.. - by fixkick - 11-20-2019, 01:11 PM
RE: Catconverter burn-up.. - by TomPrestin - 11-20-2019, 06:17 PM
RE: Catconverter burn-up.. - by fixkick - 11-20-2019, 11:08 PM
RE: Catconverter burn-up.. - by fixkick - 11-20-2019, 11:21 PM
RE: Catconverter burn-up.. - by fixkick - 11-21-2019, 12:40 AM
RE: Catconverter burn-up.. - by fixkick - 11-21-2019, 01:02 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)