Bingo, better photos, better answers
can I assume that is slider, 3/19? you need to say this is xxx bla bla.
that slided is bad, see how it wore 2 holes in the curved metal>
so take some brass stock and solder it where those hole are.
doing so and not melting the plastic takes SKILL. it can be fixed, done many. too many.
its just brass, think how to repair brass.. answer solder.
it cant be welded, or other methods , only soft solder low temp , solder and the correct flux....
the best view, is not straight on, its from corner so i can see 3D, like view. see the damage.
but I see it, the contacts wore the slider out.
simple .
to solder this use only 3 seconds heat at time, and use bottle with water spray, to spray it and cool it if you panic.
You get one shot to fix it. if the plastic melts its a goner
can I assume that is slider, 3/19? you need to say this is xxx bla bla.
that slided is bad, see how it wore 2 holes in the curved metal>
so take some brass stock and solder it where those hole are.
doing so and not melting the plastic takes SKILL. it can be fixed, done many. too many.
its just brass, think how to repair brass.. answer solder.
it cant be welded, or other methods , only soft solder low temp , solder and the correct flux....
the best view, is not straight on, its from corner so i can see 3D, like view. see the damage.
but I see it, the contacts wore the slider out.
simple .
to solder this use only 3 seconds heat at time, and use bottle with water spray, to spray it and cool it if you panic.
You get one shot to fix it. if the plastic melts its a goner
http://www.fixkick.com