04-16-2018, 01:23 AM
My mistake. When I tried it without the EGR wire connected I still had the check engine light. I tried reading the code again, but the check engine light just remained on without flashing. I flipped the check engine reset switch under the dash to the other side and then the check engine light flashed code 12. I cleared it again by disconnecting the battery for awhile. When I tried it again the check engine light turned off. So it seems to work, no check engine light with the EGR temperature sensor wire disconnected.
I am wondering about why my fuel gauge is not working. It appears to be connected to the ECM when I look at the schematic. So I am wondering if having the '93 ECM in my '95 vehicle could possibly cause my fuel gauge not to work. Do you know? Maybe it is something else. I did install a new fuel pump assembly. Will be doing more study to figure it out, but appreciate any insight you may have.
I am wondering about why my fuel gauge is not working. It appears to be connected to the ECM when I look at the schematic. So I am wondering if having the '93 ECM in my '95 vehicle could possibly cause my fuel gauge not to work. Do you know? Maybe it is something else. I did install a new fuel pump assembly. Will be doing more study to figure it out, but appreciate any insight you may have.
1995 Suzuki Sidekick JX 4WD 4-door hardtop, G16 1.6L 16 valve L4 SOHC, 4-spd Auto Trans (Asin AW Model 03-72 LE), Non-ABS, Assembled in Ingersoil, Ontario. Currently in Tok, AK.