let me guess, you tried to bolt it all up but the gap ,will not close. bell to engine.
that means the disk is in backwards, most times.
the 2nd reason is not using the alignment tool above, and the splines do not align up.
if all is right (no parts backwards)
you can bump the starter, to get the splines in to the DISC hub align with the 5speed pilot shaft splines, a 1 second bump.
the other way is rear prop shaft is on the floor , is it ?
then only put up the front end only, not rear to axle 4bolt plate.
put the trans in 4th gear (this is 1:1 ratio, 4th) and hand turn the rear prop shaft yoke by hand this will align splines too.
that is my guess.
that means the disk is in backwards, most times.
the 2nd reason is not using the alignment tool above, and the splines do not align up.
if all is right (no parts backwards)
you can bump the starter, to get the splines in to the DISC hub align with the 5speed pilot shaft splines, a 1 second bump.
the other way is rear prop shaft is on the floor , is it ?
then only put up the front end only, not rear to axle 4bolt plate.
put the trans in 4th gear (this is 1:1 ratio, 4th) and hand turn the rear prop shaft yoke by hand this will align splines too.
that is my guess.
http://www.fixkick.com