Have a question about shifter bushing repair

[fixkick]

there is no way for GL4 to go there,
only humans did that wrong,
first it have to push past all 3 of these, then
push past the shifter extensions. and filll this huge pit full of GL4, some may land here but it will ever fill up full, and for sure higher.
http://www.fixkick.com/tranny/shifting/cheating1.jpg

the only way I know is using those cheap OilQuick lube places and where they use compressed air to shove GL5 lube in the right side filler port, under huge pressure,
your discover is common, many think oil goes there, but is not true, nor is is self lubed there ,from case bottom up.
the manual tells you what to do. and is assem lube, all that , there, all rails and all extension rails lubed, and the #27 plastic too.
the whole book is there get it keep it!
https://web.archive.org/web/201011190802...7B-pdf.htm


here is the lube, used

https://www.handsontools.com/Kent-Moore-...13139.html


id say any assembly lube for trans is ok,

the maker calls out a specific lube, that is unknown to them so they guess GL4 , on page 30 of the manual, j36850 transmission assembly lube.