what trans?
the 3speed and 4speed are not even close to the same, .
4speed is super hard, drop pan, drop valve body. part 20 seen here is end of cable fitting. only dropping valve body works here.
ok i see your other posts with 3speed.
3speed fits like this. much more easy.
http://www.fixkick.com/tranny/slush/slid...-base1.jpg
that cylinder device plunger must be pulled?
FSM page 21. step 6
remove 90 degree TV clamp on 3speed box. figure 21
then figure 22, shows pulling cable to get the plunger back and get it disconnected. yes the manual is vague.
yes is spring loaded in the box or the cable would never retract, at idle.
i guess your old cable is still attached
https://web.archive.org/web/201011191005...7A-pdf.htm
this is all the book has, this 1 photo.
the 3speed and 4speed are not even close to the same, .
4speed is super hard, drop pan, drop valve body. part 20 seen here is end of cable fitting. only dropping valve body works here.
ok i see your other posts with 3speed.
3speed fits like this. much more easy.
http://www.fixkick.com/tranny/slush/slid...-base1.jpg
that cylinder device plunger must be pulled?
FSM page 21. step 6
remove 90 degree TV clamp on 3speed box. figure 21
then figure 22, shows pulling cable to get the plunger back and get it disconnected. yes the manual is vague.
yes is spring loaded in the box or the cable would never retract, at idle.
i guess your old cable is still attached
https://web.archive.org/web/201011191005...7A-pdf.htm
this is all the book has, this 1 photo.
http://www.fixkick.com