09-30-2018, 06:38 AM
holy mackerel what is that transfer case hole empty. that hole not threaded, if is that is the filler port, a 10mm square drive same as 5sp uses and bottom of both cases.
can a small screw driver blade go deep in that hole? 2 to 4 inches. or just 1/2" use flashlight look hole and see chain?
Not threaded. Pretty sure a rubber plug once lived here. You can see the rail at the end with a bit of grey glue still clinging to the back top of the hole - just like the other 2 plug holes looked like.
![[Image: 2192_29_09_18_3_15_48.jpeg]](http://www.fixkick.com/bbs2/Suzuki-bbs/gallery/2192_29_09_18_3_15_48.jpeg)
our fillers 91 up on transfer
are both on the rear. casing fasting aft
my guess is 89 are different.
No, as you can see, both service plugs are on rear of transfer case of my 89. Looked for a transfer case P/N to no avail.
![[Image: 2192_29_09_18_3_22_42.jpeg]](http://www.fixkick.com/bbs2/Suzuki-bbs/gallery/2192_29_09_18_3_22_42.jpeg)
Glad to hear 91+ years have threaded plugs instead.
Was thinking I might tap out the holes if I have a bottom plug tap and blue locktite short bolts in these 3 but worried about being able to clean out metal shavings properly.
Think I'll clean and degrease the hole well and red locktite or epoxy in some plugs made out of alum rod.
can a small screw driver blade go deep in that hole? 2 to 4 inches. or just 1/2" use flashlight look hole and see chain?
Not threaded. Pretty sure a rubber plug once lived here. You can see the rail at the end with a bit of grey glue still clinging to the back top of the hole - just like the other 2 plug holes looked like.
our fillers 91 up on transfer
are both on the rear. casing fasting aft
my guess is 89 are different.
No, as you can see, both service plugs are on rear of transfer case of my 89. Looked for a transfer case P/N to no avail.
Glad to hear 91+ years have threaded plugs instead.
Was thinking I might tap out the holes if I have a bottom plug tap and blue locktite short bolts in these 3 but worried about being able to clean out metal shavings properly.
Think I'll clean and degrease the hole well and red locktite or epoxy in some plugs made out of alum rod.