04-28-2018, 11:45 PM
the spring must be inserted in such a way that it will not fall out.
warning , only suzuki sells these springs,,,, I have the P/N if you need it,
one of mine was broken in 2, and bought one.
A head job on this car is not easy, lots of steps, 16valves and cam timing tricky, (false marks ("I") in 2 places, )
as rule a 6mm threaded bolts, never goes much over 100 inch/ lbs, (rocker bolts 132 inch is the exception)
the highest is steel in to steel or iron/
the lowest is steel bolt in to aluminum. 97inch/pounds is par. or 11 nM (newten meters) 6mm bolt topic.... treads.... always an issue on rice burners....
warning , only suzuki sells these springs,,,, I have the P/N if you need it,
one of mine was broken in 2, and bought one.
A head job on this car is not easy, lots of steps, 16valves and cam timing tricky, (false marks ("I") in 2 places, )
as rule a 6mm threaded bolts, never goes much over 100 inch/ lbs, (rocker bolts 132 inch is the exception)
the highest is steel in to steel or iron/
the lowest is steel bolt in to aluminum. 97inch/pounds is par. or 11 nM (newten meters) 6mm bolt topic.... treads.... always an issue on rice burners....
http://www.fixkick.com