So I checked all grounds good, harness good. Cranking for 5 seconds no codes other than 12. My mistake earlier I was able to get power at injector using dvm and key on. I tried to test tsp pin 3 never did see 5v only just shy of 1v cranking. the noise suppressor was plugged in and taped like it should so i started unplugging sensors. Unplugged tps no change still starts and dies plugged it back in then unplugged maf sensor and bingo engine fires up idles fine revs up fine. Plug back in maf sensor and immediately dies. I get code 22 when maf disconnected. Any ideas? Is this sensor bad or is it the tps bad confused on which one if the maf that's not cheap or what should I do next?
|
Assembly help
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Assembly help - by Soupir - 01-21-2018, 03:50 PM
RE: Assembly help - by fixkick - 01-22-2018, 06:04 AM
RE: Assembly help - by fixkick - 01-22-2018, 06:07 AM
RE: Assembly help - by Soupir - 01-22-2018, 09:44 AM
RE: Assembly help - by Soupir - 01-22-2018, 10:07 AM
RE: Assembly help - by fixkick - 01-23-2018, 10:08 AM
RE: Assembly help - by fixkick - 01-23-2018, 10:10 AM
RE: Assembly help - by Soupir - 02-26-2018, 01:58 AM
RE: Assembly help - by fixkick - 02-26-2018, 04:49 AM
RE: Assembly help - by Soupir - 03-07-2018, 06:27 AM
RE: Assembly help - by fixkick - 03-07-2018, 07:50 AM
RE: Assembly help - by Soupir - 03-08-2018, 10:01 AM
RE: Assembly help - by fixkick - 03-08-2018, 10:26 AM
RE: Assembly help - by Soupir - 04-11-2018, 12:49 PM
RE: Assembly help - by fixkick - 04-11-2018, 09:34 PM
RE: Assembly help - by fixkick - 04-11-2018, 09:36 PM
RE: Assembly help - by fixkick - 04-11-2018, 09:38 PM
RE: Assembly help - by Soupir - 04-12-2018, 11:16 AM
RE: Assembly help - by Soupir - 04-13-2018, 10:53 AM
RE: Assembly help - by fixkick - 04-13-2018, 11:04 AM
|
Users browsing this thread: 4 Guest(s)