Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sources for Rebuilt Cylinder Heads G16B
06-11-2017, 02:52 AM (This post was last modified: 06-11-2017 02:52 AM by fetcher.)
Post: #11
RE: Sources for Rebuilt Cylinder Heads G16B
I think that I am getting somewhere:

   
From: http://www.zukikrawlers.com/showthread.php?t=55121
Find all posts by this user
Quote this message in a reply
06-11-2017, 06:16 AM (This post was last modified: 06-11-2017 06:34 AM by fetcher.)
Post: #12
RE: Sources for Rebuilt Cylinder Heads G16B
I'm not so sure the indexing is critical. with the 13 teeth I think are on both drive and driven gear, the worst you could possibly
be off by is half a tooth or 1/26th of a circle or 13.8 degrees. Looks like there is enough room for adjustment to compensate and
put you back near the middle, or I have forgotten all about geometry.
Find all posts by this user
Quote this message in a reply
06-11-2017, 11:16 AM
Post: #13
RE: Sources for Rebuilt Cylinder Heads G16B
ON 2ND THOUGHT, IDK

http://fixkick.com/
Visit this user's website Find all posts by this user
Quote this message in a reply
10-03-2017, 01:25 PM
Post: #14
RE: Sources for Rebuilt Cylinder Heads G16B
Any updates?
Find all posts by this user
Quote this message in a reply
10-08-2017, 08:01 AM
Post: #15
RE: Sources for Rebuilt Cylinder Heads G16B
I thought I explained it. Indexing is not super critical. The distributor gear on the camshaft is press on. You can use the heads with the
reluctor if you switch it for the cam driven distributor gear.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)