10-27-2016, 08:25 AM
[quote='Terebit' pid='7204' dateline='1477502920']
...engine stumble and infrequent backfire (to tail pipe or air cleaner). Tailpipe, I think. I just heard a few pops, sounded like from the rear.
Recap: 1988 1/2 Samurai, 1.3L with '90 TBI conversion, ECU = 89 Tracker, coil/distributor is vintage 88? what? I think the distributer is from the original '88 1/2 engine, but this could have had an engine swap at some point.
I guess you mean the donor car was a 1.6L G16a ,1990 TBI. but that means, ECU , harnesses, sensors, TBI intake and all parts from G16. Did the Check engine light get deleted, some how? the ECU is a 56B30 on 5speed. is that it? I was under the impression that the engine was a 1.3L and only the intake was changed (if that's possible) The number on the ECU is 33920-60A31.
...no flash codes (no code 12). IT MUST, or is wired wrong or is now STUCK in backup mode. Is there a way to get out of Backup mode, if stuck there? New ECU only?
Replaced the O2 sensor a few days ago, no change.
I'll try to find the circuit problem to get flash codes
...engine stumble and infrequent backfire (to tail pipe or air cleaner). Tailpipe, I think. I just heard a few pops, sounded like from the rear.
Recap: 1988 1/2 Samurai, 1.3L with '90 TBI conversion, ECU = 89 Tracker, coil/distributor is vintage 88? what? I think the distributer is from the original '88 1/2 engine, but this could have had an engine swap at some point.
I guess you mean the donor car was a 1.6L G16a ,1990 TBI. but that means, ECU , harnesses, sensors, TBI intake and all parts from G16. Did the Check engine light get deleted, some how? the ECU is a 56B30 on 5speed. is that it? I was under the impression that the engine was a 1.3L and only the intake was changed (if that's possible) The number on the ECU is 33920-60A31.
...no flash codes (no code 12). IT MUST, or is wired wrong or is now STUCK in backup mode. Is there a way to get out of Backup mode, if stuck there? New ECU only?
Replaced the O2 sensor a few days ago, no change.
I'll try to find the circuit problem to get flash codes