05-10-2013, 10:00 PM
1.Heat rubber in hot water, then use soapy hot water to install
2a: inner or outer scraper, the outters are hard to find, it took me looking at many suzuki dealers to find it. there was one aftermarket supplier too but that too has hard to source.
2b: sure the guides all , stop rattles,as does all inner and outer scrapers. i have the p/n, , will get.
3: custom metal work. suzuki is non DIN.
4:the Suzuki has sep. frame and body, do not ever jack on the body, , frame and rear axle ok. never track rods , front cross member ok.
5: the best is , a fuel pump cut out switch. the left rear ground, is inviting...
6: unknown. Lots of folks put in 4door springs, in the 2door, and have 2 door springs laying around , useless.
7: SST rod. (nickle steel rod)
2a: inner or outer scraper, the outters are hard to find, it took me looking at many suzuki dealers to find it. there was one aftermarket supplier too but that too has hard to source.
2b: sure the guides all , stop rattles,as does all inner and outer scrapers. i have the p/n, , will get.
3: custom metal work. suzuki is non DIN.
4:the Suzuki has sep. frame and body, do not ever jack on the body, , frame and rear axle ok. never track rods , front cross member ok.
5: the best is , a fuel pump cut out switch. the left rear ground, is inviting...
6: unknown. Lots of folks put in 4door springs, in the 2door, and have 2 door springs laying around , useless.
7: SST rod. (nickle steel rod)
http://www.fixkick.com