Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
97 Tracker 5V Ref Current Capability
#1
My ECM's 5V reference falls to 1.5V with the fuel level sender plugged in. (Just replaced - old one was open.) I get an Ohms reading of 70 Ohms at the ECM connector (disconnected from ECM) with all circuits connected. That means I'm only drawing about 75 mA from the reference but it falls to 1.5 VDC. I haven't taken an Ohms reading without the fuel level sender disconnected since the reference comes back to 5VDC. (70 Ohms seems reasonable with less than half a tank of gas- the sender is 40 Ohms at empty.)
WHAT IS CURRENT RATING FOR THE 5 VOLT REFERENCE CIRCUIT??
If no one knows can someone with a 96-98 Tracker, disconnect the center connector (the ECM has three) from the ECM and take an OHMs reading from your reference circuit (gray/red wire) to ground (I used the steel dash plate directly under the steering wheel).
THANX . . . Hoping it's NOT the ECM . . . but it looks bad.
Reply


Messages In This Thread
97 Tracker 5V Ref Current Capability - by TrackerJacker - 10-24-2015, 03:31 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)