Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how to communicate Kia Pride 20pin Diagnustig connector
#25
Hi
Thank's
Excuse me for My English is bad
i know there is not have this model Care
But I See This Software http://cascade.fishpondstudios.com/ this here say hi scan pro Cascade work on Hyundai and kia supports K/L and K+CAN 1.4 interfaces with an FTDI serial-to-USB converter chip.
i do download this Software and see Room File kia General /Pride Section .i thinked this software will work on my care .Then start building Make interface . also when select on hi scan Cascade kia general/Pride 1998/1999 years model and inter . Reaction pin TX on the FT232RL 5Volt to 0 Volt also
winking Break red Color on the software (Please see Semicircular Red color on picture)
About Break on general site Manual : “break” is on when an ISO-9141 “slow init” or ISO-14230 “fast init” is performed, that is when the diagnostic software attempts to establish a connection with an ECU via K line.

- Also Baud rate is 10400
[Image: xs9ksrrmx5684j32vyaaa_s.jpg]
---------------------------------------------------------
Also i asked Many Forum : Example
http://www.kiaownersclub.co.uk/forum/top...tml#188799

http://www.batauto.com/threads/kia-pride...ace.13579/

http://www.newtiburon.com/forums/engine-...ost4922386
( this Forum MR:airkix72 tell me pin19 connect to DTR pin FT232RL . I was But not Work )
http://www.kia-forums.com/other-kia-mode...tware.html

------------------------------------------
Also i Send email To Ulrich Hecht publisher hi scan cascade . But no answer my email
-------------------------------
If possible you Can download Hi scan cascade and test TX pin on FT232rl with Voltmeter
Reply


Messages In This Thread
RE: how to communicate Kia Pride 20pin Diagnustig connector - by hamed-pc - 12-05-2015, 04:02 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)