Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hard start
#7
if timed ok, no risk of bending valves
the compression test must be done.

1battery chaarged.
2: all spark plugs out. (cops out too, sure)
3:throttle blocked open, wot.
4:crank it, until the needle peaks, write it down the PSI.

this proves engine is ok, and cam is timed.

no enigine runs with bad compression, it will be dead, misfire or run like a dog.
the ECU is tuned for good engines, not 50psi engines.
the spark must happen at the correct static time, or the ECU will mess up. the ECU ASSUMES static is correct and advances from there.
if you lie to the ECU, it will mess up..

i hope you dont bend your valves.
http://www.fixkick.com
Reply


Messages In This Thread
Hard start - by Lutzz - 01-14-2015, 08:44 AM
RE: Hard start - by fixkick - 01-14-2015, 11:24 AM
RE: Hard start - by Lutzz - 01-14-2015, 12:12 PM
RE: Hard start - by fixkick - 01-14-2015, 11:26 PM
RE: Hard start - by Lutzz - 01-15-2015, 08:58 AM
RE: Hard start - by fixkick - 01-15-2015, 12:04 PM
RE: Hard start - by fixkick - 01-15-2015, 11:35 PM

Forum Jump:


Users browsing this thread: 6 Guest(s)