Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Turn signals out after smoke in combo switch
#17
key on but no way/or tell to have blinker combo on??
key on
you hand grabs the turn signal ever and push it to left turn or right turn, why is this hard, its lever broken?

what i need is tests at the relay, the 8 tests.
do all tests at just the relay, using a DMM , then using a test light.
no need for test light is say step 1 to 5 fails in post 17 above.
we need to back probe the relay, (needle back probe it) using first the DMM (volts) and last a real test lamp. (any)
you can find an old car lamp. off wrecked car, and use that, a side lamp is best off an old car, 2 wires.
free?

i dont need the hazard working,
i only need 12vdc to pin3 on the blinker relay. if that happens we have power, to the relay.
need at least steps 1 to 3 done.
http://www.fixkick.com
Reply


Messages In This Thread
RE: Turn signals out after smoke in combo switch - by fixkick - 11-23-2014, 12:52 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)