front oil seal leaking {crank seal? cam seal}

[fixkick]

sure, great idea. put it in 4H.
and lock the manual locking hubs sure.
i find the springing action good, for those using impact hammers it keeps the treads from getting destroyed.
the impacts are way high on all guns.
the avg is less but those spikes can get you in trouble.

very good the 8v the cam has a hole and you use the drive pin, to lock it , this is show on my 8v page
the 16v the front of the head, there is a hex female plug, i used a huge hex key that fits that and it locks the cog.

8v
http://www.fixkick.com/engine/head-pull/...cam-locker


16v quoting head pull page
Cam Cog lockers: (to get the nut off. CCW)
The G16B : The valve cover shouts "16 valves" casted into the top of cover.
(16v has no lock pin hole, seen below, on the 16v we have just behind the cog wheel, on head front a large 10mm tool.
Use a large ALLEN 10mm hex key and lock the cog to the front head rail plug. CCW the cam cog bolt.
(I have 3/8 drive allen key kit, so I used it 10mm and one 3/8" ratchet extention, to lock my cog.)
( some folks just use a Giant screw driver, stuffed in the COG) (be creative! try not to do damage.)