09-04-2019, 05:57 AM
Ok. Working on it right now.
Put the jumper in without resetting, got code 24.
Then cleared by removing negative terminal and removing jumper. After 5mins connected negative and put jumper back in. Getting 12's now and took for a drive with jumper in. Note, my speedo does not work properly.
Still running 750-800 hot and dropping to 600-650 with lamps and heater on.
I have a multi meter but don't believe it will check the duty cycle.
I did find that the back side of the intake to the plenum was cracked at the hose clamps. Going to fix this and see what I have then.
Could this air leak before the air enters be my problem?
Put the jumper in without resetting, got code 24.
Then cleared by removing negative terminal and removing jumper. After 5mins connected negative and put jumper back in. Getting 12's now and took for a drive with jumper in. Note, my speedo does not work properly.
Still running 750-800 hot and dropping to 600-650 with lamps and heater on.
I have a multi meter but don't believe it will check the duty cycle.
I did find that the back side of the intake to the plenum was cracked at the hose clamps. Going to fix this and see what I have then.
Could this air leak before the air enters be my problem?