08-14-2018, 06:55 PM
(08-13-2018, 11:05 AM)fixkick Wrote:(08-13-2018, 09:33 AM)Perry Wrote:(08-13-2018, 09:09 AM)fixkick Wrote: the , trail shaft on the 4.x4 transfer case runs different plastic gears
for all 4 transmissions. (and if out side usa many different axle ratios)
the connectors on the rear must match too.
Ok so if I have the same transmission and the connectors match I’m good to go for direct swap?
there are many variances.
but yes, the head click counts are same, clicks per mile or turns pre mile (VSS is a reed clicker tells PCM speed)
the transmission speed gears are all different. per trans /axle setups. world wide, there are more
the head connector matches, connectors and pins. 13 x 10 x16 (3 connectors, and this is the pin count 96-98
Calif or federal ? is calif 55 mph limited,? i forget.
bit tacho , yes tachometer.
the heads very by if 4x4 or 2wd
and for OD lamps, 4wd lamp. and more. extra lamps is not a problem.
and for MPH usa, kmh Canada.
and abs or no abs
'
here is my head of horrors list
http://www.fixkick.com/sensors/speedo/cl...frack.html
oh and the bottom of the head ,pulled has the suzuki p/n on a sticker there matching above list
Perfect I think I'm good for the swap! you the man!