Login Register

Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
motor stumbles after it warms up
#11
there are a huge number of G13 heads, G13a, b, ab, bb (one is a twin cam)
each cylinder in G16 is 400cc.
the G13 is 75cc less, at 325 cc per cyl
if you ram 400cc slugs of air into any 1.3 head, the compression ratio will be crazy high. at the least huge detonation or the need for RACING FUEL 115 octane.
if it fit at all.
http://www.fixkick.com
Reply


Messages In This Thread
motor stumbles after it warms up - by sspence81 - 09-20-2016, 02:31 AM
RE: motor stumbles after it warms up - by fixkick - 09-20-2016, 06:20 AM
RE: motor stumbles after it warms up - by fixkick - 09-20-2016, 09:56 AM
RE: motor stumbles after it warms up - by Terebit - 10-27-2016, 03:28 AM
RE: motor stumbles after it warms up - by fixkick - 10-27-2016, 05:13 AM
RE: motor stumbles after it warms up - by Terebit - 10-27-2016, 08:25 AM
RE: motor stumbles after it warms up - by fixkick - 10-27-2016, 09:04 AM
RE: motor stumbles after it warms up - by fixkick - 10-27-2016, 09:19 AM
RE: motor stumbles after it warms up - by fixkick - 10-27-2016, 09:22 AM
RE: motor stumbles after it warms up - by Terebit - 10-27-2016, 09:44 AM
RE: motor stumbles after it warms up - by fixkick - 10-27-2016, 09:30 AM
RE: motor stumbles after it warms up - by Terebit - 10-28-2016, 10:30 AM
RE: motor stumbles after it warms up - by fixkick - 10-28-2016, 09:29 PM
RE: motor stumbles after it warms up - by fixkick - 10-28-2016, 09:47 PM
RE: motor stumbles after it warms up - by fixkick - 10-28-2016, 10:19 PM
RE: motor stumbles after it warms up - by fixkick - 10-28-2016, 10:42 PM
RE: motor stumbles after it warms up - by fixkick - 10-29-2016, 12:11 AM
RE: motor stumbles after it warms up - by fixkick - 10-29-2016, 12:34 AM
RE: motor stumbles after it warms up - by fixkick - 10-29-2016, 01:06 AM
RE: motor stumbles after it warms up - by fixkick - 11-02-2016, 11:22 PM
RE: motor stumbles after it warms up - by fixkick - 04-24-2017, 09:23 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)