Where do these hoses go?! - Printable Version +- Car Repair Forum (https://fixkick.com/forum) +-- Forum: Suzuki (https://fixkick.com/forum/forum-suzuki) +--- Forum: Sidekick/Tracker (https://fixkick.com/forum/forum-sidekick-tracker) +--- Thread: Where do these hoses go?! (/thread-where-do-these-hoses-go) |
Where do these hoses go?! - Zackman - 12-01-2015 Hello: I changed my son's sidekick's engine. I have managed to put everything back to the correct locations and hook ever hose up, with the exception of the two hose shown in attached pictures. I have looked through two manuals that I have, and spent one hour on the Internet, but could not any leads. Could someone tell me (or hopefully show me a picture), as where these hoses should be connected to? I believe they should be brake vacuum hoses? Thank you in advance. The cut-nut RE: Where do these hoses go?! - fixkick - 12-01-2015 off my find parts page http://www.fixkick.com/sensors/8v-intake.JPG it heats the fresh air to the ISC valve , faster warmups. part 18 is fresh air from the intake tube 22 goes to ISC nipple top left. its only an air heater, might prevent icing too. RE: Where do these hoses go?! - Zackman - 12-01-2015 God bless you fixkick! Would you know the size of the nut that holds power steering pully to engine. It looks either M12x1.25 or M12x1.5. I have LOST it!! Cheers, Zackman RE: Where do these hoses go?! - fixkick - 12-02-2015 nut? pulley? not sure what part of P/S is there but one part that size? buy 2 bolts that size ,both ISO pitches, and bingo found it, or use your scrap box of bolts, find size that fits. and use the pitch gauge to measure it? the suzuki parts lists do not cover size... (ignorance makes them rich) RE: Where do these hoses go?! - Zackman - 12-02-2015 Hi Fixkick: I am talking about the bolt holding teh pulley in attached picture? Cheers, Zackman RE: Where do these hoses go?! - fixkick - 12-02-2015 the pump is off walk in to any store that sells, metric nuts its only 2 ISO sizes. one fits. ace home centers. even in metric SST, (nice idea that in some cases) stainless steel... all napa stores. all autostores have metric section. 1.75 1.25 one fits. i dont have a pump here or would measure it. i have pitch gauge. http://www.lowes.com/pd_576750-281-12016___?Ntt=irwin+metric+gauge&UserSearch=irwin+metric+gauge&productId=50146288 one of my most useful tools... working any rice cars. RE: Where do these hoses go?! - Zackman - 12-02-2015 Many thanks Fixkick! Will do as suggested. Cheers, Zackman RE: Where do these hoses go?! - fixkick - 12-03-2015 i hope its only dirty. cheers.! |